Admin

Here you will have access to the advanced calibration settings for the configuration of the Presets (see PRESETS).

Warning: the default values have been carefully chosen to allow the automatic filming to adapt to all situations. Any modifications here may lead to the “blocking” of situations, where the AI cannot match the shot to the microphone detection.

• Minimum SOLO presets per microphone: As a default, the system expects at least 1 preset per microphone. If you would like to have richer and more dynamic automatic filming, you can under any circumstances add some, but you can also force it to systematically configure more presets by increasing this value.
• Minimum camera(s) for SOLO presets: The setting is useful if you foresee more than one preset per microphone, allowing for the obligation to configure the different cameras and thus achieve a reactive automatic filming.
• Minimum WIDE presets: As a default, the system expects at least 2 wide shots. If you reduce this number to 1, there will only be one shot in the event of no dialog.
• Minimum camera(s) for WIDE presets: As a default, the system expects at least 2 different cameras for the Wide Presets. Be careful, this value is correlated to the previous one.
• Fixed camera re-use: As a default, the system prohibits re-using a fixed camera for different presets. In fact, there is a good chance that the shot will only be adapted to one situation. However, certain situations imply that this camera covers different events and needs to be re-used.

RESET CONFIG

This button allows you to restart the wizard for the configuration of the CONF system, by allowing you to modify the number of microphones, for example.